APC Smart-UPS RC 1000VA 230V - SRC1000I

Inquiry APC Smart-UPS RC 1000VA 230V - SRC1000I



InfraStruXure Manager Compatible: Enables centralized management via the APC InfraStruXure Manager.

Network manageable: Provides remote power management of the UPS over the network.

LED status indicators: Quickly understand unit and power status with visual indicators.

SmartSlot: Customize UPS capabilities with management cards.

Serial connectivity: Provides management of the UPS via a serial port.



Cold-start capable: Provides temporary battery power when the utility power is out.

Resettable circuit breaker: Easy recovery from overloads; no need to replace a fuse.

Safety-agency approved: Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.

Input power factor correction: Minimizes installation costs by enabling the use of smaller generators and cabling.

Generator compatible: Ensures clean, uninterrupted power to protected equipment when generator power is used.

Frequency and voltage regulation: Gives higher application availability by correcting poor frequency and voltage conditions without using the battery.

Power conditioning: Protects connected loads from surges, spikes, lightning, and other power disturbances.



User-replaceable batteries: Increases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR)

Disconnected battery notification: Warns when a battery is not available to provide backup power.

Audible alarms: Provides notification of changing utility power and UPS power conditions

Automatic self-test: Periodic battery self-test ensures early detection of a battery that needs to be replaced.

Predicitive failure notification: Provides early-warning fault analysis ensuring proactive component replacement.


Temperature-compensated battery charging: Prolongs battery life by regulating the charge voltage according to battery temperature.

Automatic restart of loads after UPS shutdown: Automatically starts up the connected equipment upon the return of utility power.

Intelligent battery management: Maximizes battery performance, life, and reliability through intelligent, precision charging.

Scalable runtime: Allows additional run time to be quickly added as needed.

Automatic internal bypass: Supplies utility power to the connected loads in the event of a UPS power overload or fault.

Hot-swappable batteries: Ensures clean, uninterrupted power to protected equipment while batteries are being replaced.



Flash upgradeable firmware: Install maintenance releases of firmware remotely using FTP.

Rack/Tower convertible: Protects the initial investment in the UPS when migrating from tower to rack-mount environment.

Plug-and-Play external batteries: Ensures clean, uninterrupted power to the loads when adding extra runtime to the UPS.



Output power capacity 800Watts / 1.0 kVA
Max Configurable Power (Watts) 800Watts / 1.0 kVA
Efficiency at Full Load 88.0 %
Nominal Output Voltage 230V
Output Frequency (sync to mains) 50/60 Hz +/-1 Hz
Output Voltage Distortion Less than 2%
Topology Double Conversion Online
Waveform type Sine wave
Nominal Input Voltage 230V
Input frequency 47 - 63 Hz
Input Connections IEC-320 C20
Cord Length 1.22meters
Batteries & Runtime
Battery type Maintenance-free sealed Lead-Acid battery with suspended electrolyte : leakproof
Included Battery Modules 1
Typical recharge time 3hour(s)

Write a review

Note: HTML is not translated!
    Bad           Good

  • Views: 877
  • Brand: APC
  • Product Code: PSUP-05
  • Availability: Inquiry
  • Rs62,000